What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 03:59
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
The bolt then partially travels down the line to your home.
He then describes Rainy Season and Lightning.
There are three different concepts here that are getting confused.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is where this question deviates from being a 'generic' question, and becomes more specific.
In schematic diagrams this is the symbol for a fuse:
At least they know the answer if they wanted it.
There are two important concepts here.
2024–10–16 [ OO OLAOYE OYEBODE ]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Upvotes:
What is it like to be a Christian in Iran?
It seems Mohan does not understand the difference between a comment and an Answer.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
The other is “what does a “fuse” do?”
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
A circuit breaker is similar, but is resettable.
Rare Red Sprite Photographed in Tibet Dazzles Social Media - PetaPixel
Now when you have a certain ac resistance, then a current flows in a loop.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
One
Has anyone liked being made a cocksucker?
Here is a simplified AC power diagram.
So, the voltage could go up to 500 volts, and the fuse will not open up.
[old diagram got deleted by accident]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
What is lightning?
Italy citizenship referendum polarises country - BBC
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
a photo is worth a thousand words.
2025 U.S. Nationals: Day 2 Prelims Live Recap - SwimSwam
Can the fuse protect the electronic devices from lightning instead of a surge protector.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
It also is a device that limits the change in current flow.
2024–10–10[John johnson John Johnson ]
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
But it can get overloaded, and no longer works.
Edit 2024–10.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
He then describes the function of a fuse.
The MOV will conduct when the voltage exceeds 50% of line voltage.
so, what happens?
but I think this circuit , shows a few more pieces.
What does a fuse do?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
These devices are installed between the “hot” and “neutral” and protective ground.
This device then solves the entire problem.
An AC voltage/ current source, and an ac inductive load.
One is “what exactly is in a ‘surge protector’ ? ”
but this device (an Inductor) … impedes the rapid changes in the current.
2024–10–14 [Omar Gharbi Omar Gharbi ]
what exactly is a ‘surge’ protector?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
At one ohm, the resistor has a maximum of 1 watt power.
These are simplified answers to the original question, and does not change anything I wrote above.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
First Sentence:
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
(Dc diagram shown, AC is similar).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is where the MOV conducts again, and dissipated the energy.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Barnstars:
nine
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
The third is lightning and “how it gets conducted into a home.”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
A fuse is a non-resetable over current circuit protector.
I post the exact comment here.
This one hit behind the barn.
[image of Common-mode choke]
For this case there are devices called Metal oxide varistors (MOV).
This is 'the assistant's answer'
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
But… the neutral is now “floating” because of the 1 ohm resistance.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
eight
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Because the load is inductive, the current lags the voltage.(by a bit).
He then asserts :
the problem then depends on "how fast does the fuse operate?".